I typed in GET listserv MAILTPL for DEFAULT and all my listservs. I got the corresponding template for them. I do not see a bottom_banner entered on these. I sent the commands exactly the way you put them now to see how this works. I have not received anything as of now. I'll let you know whether or not I received the corresponding template. I am reading the manual to find a way to edit these templates. I tried putting PUT listserv MAILTPL BOTTOM_BANNER PW=XXXXXXX (I substituted the X's for my password). I am not sure if this is correct since I did not get a response from the Listserv. Thanks. -----Original Message----- From: LISTSERV list owners' forum [mailto:[log in to unmask]] On Behalf Of Rich Greenberg Sent: Tuesday, December 06, 2005 3:12 PM To: [log in to unmask] Subject: Re: Hand coded disclaimer On: Tue, Dec 06, 2005 at 12:48:37PM -0500,Rodriguez, Pedro Wrote: } The way that I access and edit my listserv is through e-mail using text } commands. I do not use the web interface nor know how and where to } access this interface. } } I may or may not have access to that file. I may check whatever template } file I have or read the manual for commands to change the template (if } it exists). Send the following to the Listserv making the obvious corrections: // job pw=yourpasswd get listname-l mailtpl // eoj You will get back either an error saying that the mailtpl doesn't exist or you will get back the existing mailtpl file. Save it Let us know which you got. -- Rich Greenberg N6LRT Marietta, GA, USA richgr atsign panix.com + 1 770 321 6507 Eastern time zone. I speak for myself & my dogs only. VM'er since CP-67 Canines:Val, Red & Shasta (RIP),Red, husky Owner:Chinook-L Atlanta Siberian Husky Rescue. www.panix.com/~richgr/ Asst Owner:Sibernet-L