This is a weekly newsletter. Auto-Delete= Yes,Full-Auto,Delay(2),Max(1),Probe(0) If the failing address bounces 1 in 2 days then the subscriber would be dropped from the list correct? Is that how I would read the above? Rob J. Carpenter Unix System Administrator 600 Community Drive Manhasset, New York, 11030 email: [log in to unmask] or [log in to unmask] Phone: 516-562-5907 / Cell: 516-532-2951 -----Original Message----- From: LISTSERV site administrators' forum [mailto:[log in to unmask]] On Behalf Of [log in to unmask] Sent: Monday, January 09, 2006 4:49 PM To: [log in to unmask] Subject: Re: Listserv Auto-Delete At 2:33 PM -0500 1/9/06, Ki Song wrote: > >> I believe this problem has been fixed. The Auto-Delete setting: > >> Auto-Delete= Yes,Full-Auto, Delay(9)), Max(2), Probe(30) > > > This is probably a typo, but I see that there's an extra parenthesis > > in Delay(9)). > >You're right. It was a typo. My delay setting is set to Delay(90) > >Is that better? Ah, OK. That would result in an address being removed if there were more than 2 bounces in 90 days. If you want addresses to be removed after bouncing for two consecutive mailings I would use Max(1) instead of Max(2). -- Jacob Haller, Technical Support, L-Soft international, Inc LISTSERV (R) is a registered trademark of L-Soft. Support is available 9:00-18:00 ET, Monday-Friday except on the following holidays: <http://www.lsoft.com/resources/holidays.asp> All of our manuals are available for download at <http://www.lsoft.com/resources/manuals.asp>