Len Burns <[log in to unmask]> asked and a couple of others want the answer: > I hope this has not been answered several dozen times. I am managing a > list from a non-Bitnet site so everything I do must be via email. I am > needing to make files available on the listserv for subscribers and am > looking for the steps I need to get them there along with a description. You can send files via email with a PUT command as the first line. Here is an example: PUT KIDART ART003 KIDART "TITLE=Fax Art Wellington NZ July 91" pw=xxxxxx 1 2 3 4 5 1&2 - the filename & filetype. After the file is stored, it can be retrieved with the command: GET KIDART ART003 3 - the filelist in which the file is to be stored. 4 - the title that will be listed in the index of files 5 - the password for storing files. A list owner will usually *not* be able to store files until the LISTSERV manager has set up the file area for the list (this is not automatic even if the list is archived) and established the password. So please check this with the manager of the LISTSERV you are using before you try this. I have not had any troubles doing this by email. But all my files have line lengths less than 80 characters. As another message today noted, there are problems PUTing lists back on the LISTSERVer because the lines greater than 80 characters in length get wrapped around. Peace, Dan << Daniel D. Wheeler Internet: [log in to unmask] >> << University of Cincinnati Bitnet: wheeler@ucbeh >>