Is there any way possible to configure a list so that the LISTSERV will not
detect delivery errors? We would like to setup a list to receive bounces
from another application and archive/distribute them -- however, they all
get detected as delivery errors (which they are) and are not sent out to
the list (which we want them to be).

We have found a temporary work-around which we do not like at all by
setting "Errors-to" to point back to the list. At least this way, the
bounces are being archived.

Here are the settings we have now that should matter:

Loopcheck= None
Safe= No
Errors-To= [log in to unmask]
Filter= Only,[log in to unmask]

Is there a way to turn off error detection completely for a list without
sending errors to the list as a stop-gap?

-- DCP



--
Douglas Palmer                          | Voice: 718-260-2291 Fax: 718-260-2338
SystemsManager, USDC-EDNY       | Notes: /NYED/02/USCOURTS
225 Cadman Plaza East                   | Email: [log in to unmask]
Brooklyn, New York 11201                | CCNP