Thu, 28 Jul 1994 09:26:09 -0400
|
I notice that the 'reply-to' header on LISTSERV mailings (when present) says
Reply-to:
(note the lower case 't' in 'to'). When I attempt to reply to such mailings,
my mail system (elm 2.3) does not recognize this header as it is apparently
looking for
Reply-To:
(note upper case 't' in 'to').
When I expressed disatisfaction with this state of affairs, I was told that the
former construction (the one used by LISTSERV) is incorrect.
Frankly, I doubt this but would like some ammunition in support of my position.
Can anyone provide this?
Thanks...
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
+-+ John Arnfield +-+ Department of Geography +-+
+-+ BITNET/EARN: AJA+@OHSTMAIL +-+ The Ohio State University +-+
+-+ Internet: [log in to unmask] +-+ Columbus, OH 43210-1361 +-+
+-+ Telephone: +1 614 292 7954 +-+ USA +-+
+-+ Fax: +1 614 292 6213 +-+ +-+
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|
|
|