>I was wondering if there was any way to delay a specific message from being >sent. > >Thanks, > >Rebecca Elliott There are a couple of methods you can try depending on the exact circumstances. I will assume that you're talking about a mailing list that is is Send= Editor,Hold,Confirm or similar. If this is the only message that is going to be sent during the time period you could set a Prime= value for the mailing list. For instance Prime= "MON-TUE: 00:00-23:59; WED-SUN: -" would delay any messages sent on Monday or Tuesday until the midnight seperating Tuesday and Wednesday. (The message could be confirmed before then.) If the above isn't an option, you could try the following: 1) Issue the message and wait for the confirmation. Say the confirmation code is AB0013E4. 2) Send a message to listserv with the following in the body of the message: //X PRIME="MON-TUE: 00:00-23:59; WED-SUN: -" OK AB0013E4 /X EOJ If the above is sent on Monday or Tuesday this will prevent the "OK AB0013E4" command from being executed until the midnight preceding Wednesday. The PRIME= syntax needs to be exactly right so be very careful when putting these together. It is probably a good idea to test the above concepts on a test mailing list to make sure you understand how they work before using them with an active mailing list. A discussion of Prime settings can be found in section 12.3 of the Site Manager's Manual and a discussion of JOB syntax can be found in Chapter 3 of the Developer's Guide. Thanks, -- Jacob Haller, Technical Support L-Soft international, Inc http://www.lsoft.com/