Barbara: Like many automated error messages, this one can be misleading (i.e., gives the wrong reason): 1. In your email program, make sure Line Wrap is disabled before sending PUT message 2. Eliminate quotes and any other extraneous material Please use a Subject in your queries so readers can scan and track your messages and replies. Karl At 12:03 AM 5/14/02 -0400, Barbara Passman wrote: >Can anyone please advise./ >Suddenly, after moving to a new computer and updated operating >system, I can no longer send commands to LIST. > I get my list header, and return it via PUT command, adding my password. >I have NO signature file attached to my email program yet I get the >following message time and time again. > > I have added no subscribers >I have made no key word changes >Here is the message I am getting . >*********************************** >WARNING: new subscriber data was found in the replacement list you sent, >possibly due to the use of a signature file with an unusual separator line. >If you really meant to update the subscriber data, please resend your >request with the word "PUT" replaced with "PUTALL". For now, only the list >header will be updated. > >The following problems have been detected in the list header: > >* Owner= <Missing> >Error: The "Owner=" keyword has no default value and may not be omitted. > >* Notebook= ... >Error: The first two parameters of the "Notebook=" keyword may only be updated > by the LISTSERV administrator. > >* Sub-Lists= ... >Error: The "Sub-Lists=" keyword may only be updated by the LISTSERV > administrator.