About 30% of the commands sent by users to our LISTSERV are failing because they are misidentifed as empty. Users are getting back this message: * Your message is being returned to you unprocessed because no command was * found in the message body. LISTSERV expects commands in the body of the * message, rather than in the message subject, because some users have no * control over the contents of the "Subject:" field on outgoing messages. 1.8e cannot catch one-line commands in MIME encoded messages like earlier versions could. I really need to change this message so that users will know to resend their message with a <CR> at the end of the command -- but it looks like it is hard-coded into lsv/lsv.o. Is anyone else seeing this? -- DCP -- Douglas Palmer | Voice: 718-260-2291 Fax: 718-260-2338 SystemsManager, USDC-EDNY | Notes: /NYED/02/USCOURTS 225 Cadman Plaza East | Email: [log in to unmask] Brooklyn, New York 11201 | CCNP