I apologize if this question has been asked before, but since I'm a relatively new member of this list I wonder if someone can point me to an answer. I'm trying to set up a list for which I am the editor, along with several other people. I'd like all mail from general contributors forwarded to me, but I also want each of the editors to be able to send mail directly to the list. In the document "ListKeyW Memo" I found the following advice: >* Editor= (net-address1),(net-address2),... * >********************************************* > Defines the list editor(s). When used in conjunction with the "Send= > Editor" option, it causes all mail sent to the list to be automatically > forwarded to the first person listed in the "Editor=" keyword, who will > then send it back to the list at his discretion. The editors are the > only persons (with the list owners) who are allowed to mail directly to > the list. Note that ANY editor can send mail to the list while only the > FIRST one will receive copies of mail sent to the list. This led me to believe that all I needed to do was add e-mail addresses and names separated by commas as in the header that follows below: >* OWNER= SUPPORT@RPIECS (Comserve Support Staff) >* ERRORS-TO= SUPPORT@RPIECS (Comserve Support Staff) >* EDITOR= HARRISON@RPIECS (T. Harrison), STEPHEN@RPIECS (Tim Stephen), >* COMSPRT3@RPIECS (Some Body) Unfortunately, when I tried to test the system, the additional editors specified were not able to submit directly to the list; their mail was also forwarded to me. Can anyone tell me where I've gone wrong? Thanks, Teresa M. Harrison RPI