I got a message from someone subscribed to RRA-L hosted here at KENTVM about not being able to post a message to the RRA-L list since LISTSERV was updated to 1.7d. Other people on the list seemed to be able to post (it's a moderated list) and get forwarded to the list by the editor. Did this happen anywhere else or is it something I did wrong? Christine Shih SHIH@KENTVM Postmaster at KENTVM A copy of the complaints is attached below: -------------------------------------------------------------------- >I receive the error message below when trying to submit messages >to RRA-L. I have tried sending messages from several different >machines and receive the same result. Prior to 9/15 I was able >to successfully submit postings. The listserv appears to be trying >to interpret the first line of my message as a command, which it >doesn't understand. > >I use this command to post: > >mail [log in to unmask] > >Any help you may give is greatly appreciated! > > >***************ERROR MESSAGE FOLLOWS:************* > >Received: by icarus.colorado.edu (cu.generic.890828) >Received: from KENTVM.BITNET by Kentvm.Kent.edu (IBM VM SMTP R1.2.2MX) with > BSMTP id 6766; Wed, 16 Sep 92 12:39:27 EDT >Received: by KENTVM (Mailer R2.08) id 1535; Wed, 16 Sep 92 12:39:26 EDT >Date: Wed, 16 Sep 1992 12:39:12 -0400 >From: Revised List Processor (1.7d) <[log in to unmask]> >Subject: Output of your job "gratrix" >To: [log in to unmask] >Status: R > >> ----------------------------Original message---------------------------- >Unknown command - "----------------------------ORIGINAL". Try HELP. > >All subsequent commands have been flushed. > >Summary of resource utilization >------------------------------- > CPU time: 0.007 sec Device I/O: 0 > Overhead CPU: 0.003 sec Paging I/O: 0 > CPU model: 4381 DASD model: 3380 > >Thanks for looking into the matter. After further investigation >myself I found that the problem started when the software you are >running was changed from (1.7c) to (1.7d) (see below) >I have tried several times to post my message again, but >without any success. > >Thanks again, > >> Date: Mon, 14 Sep 1992 23:22:38 -0400 >> From: Revised List Processor (1.7c) <[log in to unmask]> >> Subject: Output of your job "RRA-L" >> To: [log in to unmask] > >> Your mail file (1294) was successfully DISTRIBUTEd to list RRA-L. > > >> Date: Tue, 15 Sep 1992 16:33:01 -0400 > From: Revised List Processor (1.7d) <[log in to unmask]> >> Subject: Output of your job "gratrix" >> To: [log in to unmask] >> Status: RO > >> > > From: Diane Trap <[log in to unmask]>