I notice that the 'reply-to' header on LISTSERV mailings (when present) says Reply-to: (note the lower case 't' in 'to'). When I attempt to reply to such mailings, my mail system (elm 2.3) does not recognize this header as it is apparently looking for Reply-To: (note upper case 't' in 'to'). When I expressed disatisfaction with this state of affairs, I was told that the former construction (the one used by LISTSERV) is incorrect. Frankly, I doubt this but would like some ammunition in support of my position. Can anyone provide this? Thanks... +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ +-+ John Arnfield +-+ Department of Geography +-+ +-+ BITNET/EARN: AJA+@OHSTMAIL +-+ The Ohio State University +-+ +-+ Internet: [log in to unmask] +-+ Columbus, OH 43210-1361 +-+ +-+ Telephone: +1 614 292 7954 +-+ USA +-+ +-+ Fax: +1 614 292 6213 +-+ +-+ +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+