>Is there any way to bulk add users so they are notified and given a welcome >email? Using the command: >Add listname emailaddress first last You didn't say what platform you were using, but using VM and REXX it's easy. 1. create a flat file called list names (or whatever) information separated by a blank space. listname [log in to unmask] First Last 2. code a rexx exec called addusers exec (or whatever exec) /* read in list names and add to appropriate list */ 'EXECIO DISKR LIST NAMES A 1 ( FINIS STEM ADDU.' 'set cmstype ht' ; 'set msg off' ; 'set imsg off' ; 'set wng off' do n=1 to addu.0 parse var addu.n list addr first last . 'exec tell listserv add 'list addr first last end 'set cmstype rt' ; 'set msg on' ; 'set imsg on' ; 'set wng on' exit note: setting cmstype, msg, imsg, wng aren't necessary, but I wouldn't wish to see all the messages bouncing around on the screen. Also keep in mind the exec will execute faster that listserv can process the commands, so once the exec is finished and messaging has been restored, you might want to log off or manually turn off messages. 3. run from the listserv maintainers userid, just type addusers Very elementary, but effective. You could easily add additional code to record each person added, update the screen as users are added, etc... The same process should be similar accross different platforms. Now if you wanted to send a message other than the standard blurb, then you'd have to create a filelist for that list, put an entry in the list's filelist as follows: filename = listname filetype = welcome, create and store file listname welcome on Listserv server. The welcome message would be sent with the standard blurb when a user is added. Keep in mind the procedures described above are for Listserv installed on VM! Howard