As far as I know, there is no one-step method in 1.8c using the new interface. One must do so recursively by observing the output DATE field and reissuing with a date-spec. Checkout the following tutorial by Jared Weinberger: http://www.mindspring.com/~jaredmarkw/search.htm Also, if your list is on a WEBserver, there are certain other possibilties. /Pete Weiss at Penn State, operator of LDBASE-L At 08:19 6/30/97 -0400, you wrote: |I need to get more than 100 lines of results from the SEARCH command in |1.8c. Does anyone know the syntax for the command that will allow this? | |Thanks for any help. | |- Ralph | |Ralph Stuart |Chemical Safety Coordinator |University of Vermont |655 Spear St., PO Box 50570 |Burlington, VT 05405 | [log in to unmask] |fax: (802)656-5407 | |Owner: SAFETY list (general discussion of environmental health and safety) | LEPC list (planning for hazardous materials emergencies) | LAB-XL list (performance oriented enviromental regulation of |laboratories) | |