Greetings Listowners: Can anyone help us with the problem of tailoring the names attached to E-mail addresses in the "From:" header on Listserv postings? Ours is a monitored list. At the time of subscription, our subscribers include their own names in the subscribe command, rather than the name used by their server, e. g. subscribe Alpine-L Sheila Paulson That command creates the following entry in the subscriber list (the full list header) that is retrievable by the Review Alpine-L command: [log in to unmask] Sheila Paulson However, when Sheila posts a message to Alpine-L its "From:" header reads: From: Cliff Paulson <[log in to unmask]> Clearly, Listserv has taken the "From:" header's information either from the Paulsons' server's database (which uses husband Cliff's name) or from the Listserv REGistry database, into which hubby Cliff may have inserted information via the REG command. A small percentage of Alpine-L postings display, in the "From:" header, subscribers' ID's taken from the Alpine-L subscribers' directory, which is based on information supplied by the SUBSCRIBE and/or ADD commands. My question is this: Is there any way to get Listserv to consistently use the list subscriber information in the return portion of the messages? What is it that sometimes causes Listserv to pull this information from the full list header, while at other times it does not? To summarize: Listserv seems to use up to three different sources of return address for every subscriber: 1. In posted messages, a "From:" header as sent by the subscriber's ISP. For some subscribers, this is the only type of "From:" header used. 2. In posted messages, a "From:" header generated by Listserv from the subscribers' directory (the full header) for the list subscribed to. For a few subscribers, this is the only type of "From:" header used. 3. In messages reporting "Outcome of your job", a "From:" header generated by Listserv from a central Listserv database; the contents of this central database is created when subscribers send in a REG command. It appears that this central REGistry (if I may call it that) is NEVER used for the "From:" header in messages posted to the list by subscribers. Ideally, we would like to have all messages posted to the list by our subscribers use source no. 2 (the full header) above. Is there any way to do this consistently? Thanks, Louise Alpine-L, the Electronic Rock Garden Society Louise Parsons & Harry Dewey, active listowners Eric Gouda, Alexej (Sasha) Borkovec, quiet listowners <[log in to unmask]> Please, write to active listowners at the above address To join Alpine-L, send the message INFO to the above address http://www.peak.org/~parsont/rockgard/ ****************************************************