Wed, 7 Dec 2005 08:29:02 -0500
|
I did receive a response and it said to be a bad command. It did not affect my template.
By the way, thank you Rich for the command. I will try it to see how it works.
Thanks,
Pedro J. Rodríguez
Software Engineer II
Northrop Grumman Information Technology
E-Mail: [log in to unmask]
-----Original Message-----
From: LISTSERV list owners' forum [mailto:[log in to unmask]] On Behalf Of Rich Greenberg
Sent: Tuesday, December 06, 2005 4:18 PM
To: [log in to unmask]
Subject: Re: Hand coded disclaimer
On: Tue, Dec 06, 2005 at 03:46:03PM -0500,Rodriguez, Pedro Wrote:
} I typed in GET listserv MAILTPL for DEFAULT and all my listservs. I got } the corresponding template for them. I do not see a bottom_banner } entered on these. I sent the commands exactly the way you put them now } to see how this works. I have not received anything as of now. I'll } let you know whether or not I received the corresponding template.
I don't know what the for DEFAULT gets you.
} I am reading the manual to find a way to edit these templates. I tried } putting PUT listserv MAILTPL BOTTOM_BANNER PW=XXXXXXX (I substituted the } X's for my password). I am not sure if this is correct since I did not } get a response from the Listserv.
You may have destroyed something, that command is bad.
The right way is to send:
PUT listname-L mailtpl PW=xxxxxxxx
[insert complete original mailtpl here]
>>> Bottom_Banner
[Insert what you want in your bottom header here]
then make sure that NOTHING follows the last line. No sig or anything else and send to the listserv.
--
Rich Greenberg N6LRT Marietta, GA, USA richgr atsign panix.com + 1 770 321 6507
Eastern time zone. I speak for myself & my dogs only. VM'er since CP-67
Canines:Val, Red & Shasta (RIP),Red, husky Owner:Chinook-L
Atlanta Siberian Husky Rescue. www.panix.com/~richgr/ Asst Owner:Sibernet-L
|
|
|