 
Leonard D Woren <LDW@USCMVSA>
Fri, 27 Jan 89 23:44:00 PST
|
Anyone have any ideas on why the following message was distributed to
the IBM-MAIN list??? (I am not a new subscriber to IBM-MAIN.)
---------------------------- Text of forwarded message -----------------------
Received: (from <[log in to unmask]> via BSMTP at ADMIN.BYU.EDU)
Received: (from MAILER@BYUADMIN for MAILER@USCMVSA via NJE)
(UCLA/Mail V1.410 M-MAILER-6014-42); Fri, 27 Jan 89 20:34:57 PST
X-RSCS-Info: FileName=IBM-MAIN FileType=MAIL DistCode=RUTVM1
Received: by BYUADMIN (Mailer R2.01A) id 6012; Fri, 27 Jan 89 21:33:01 MST
Date: Fri, 27 Jan 89 16:37:00 CST
Reply-To: IBM Mainframe Discussion List <[log in to unmask]>
Sender: IBM Mainframe Discussion List <[log in to unmask]>
From: "1.5o Revised List Processor" <[log in to unmask]>
Subject: Your subscription to list IBM-MAIN
To: Leonard D Woren <LDW>
Dear networker,
Your subscription to list IBM-MAIN (IBM Mainframe Discussion list) has been
accepted.
You may leave the list at any time by sending a "SIGNOFF IBM-MAIN" command to
[log in to unmask] Please note that this command must NOT be sent to the list
address (IBM-MAIN@RICE) but to the LISTSERV address (LISTSERV@RICE).
The amount of acknowledgement you wish to receive from this list upon
completion of a mailing operation can be changed by means of a "SET IBM-MAIN
option" command, where "option" may be either "ACK" (mail acknowledgement),
"MSGACK" (interactive messages only) or "NOACK".
Please note that it is presently possible for anybody to determine that you
are signed up to the list through the use of the "REVIEW" command, which
returns the network address and name of all the subscribers. If you do not wish
your name to be available to others in this fashion, just issue a "SET IBM-MAIN
CONCEAL" command.
More information on LISTSERV commands can be found in the "General
Introduction guide", which you can retrieve by sending an "INFO GENINTRO"
command to [log in to unmask]
Virtually,
The LISTSERV management
|
|
|
