"Revised List Processor (1.5f)" <LISTSERV@CLVM>
Tue, 20 Jan 1987 07:13 EST
|
oops....
The standard message below lists "MSGack" as a valid option for setting
my ACK option, which implies the shortest response allowed is "MSG".
This doesn't work, I had to use "MSGACK" spelled out.
Trivial, but I tripped over it.
Drew
----------------------------Original message----------------------------
Dear networker,
As of Tuesday, January the 20th of 1987, you have been added to the LISTSERV
distribution list LSTSRV-L (The Revised LISTSERV distribution list) by Eric
Thomas <ERIC@FRECP11>.
Please note that you can change the amount of acknowledgement you wish to
receive from this list upon completion of a mailing operation. The command to
be used is the "SET" command, whose general syntax is "SET listname ACK|MSGack|
NOACK". More information about this command can be found in the LISTSERV
General Introduction guide which you can obtain by sending an "INFO" command to
[log in to unmask]
Virtually,
The LISTSERV management
|
|
|