(Reply from Randy Klumph)

I rechecked the list config and found that the syntax was ChangeLog=
Yes (rather than Change-Log). I ran a changelog on another list with
the correct syntax and it generated the report. However, I updated the
log-main as indicated in the FAQ but it is still only goes to 2003. I
pasted the line from the example for each section of the file (noting
case sensitivity). Below is a clipped portion of the sections. I'm not
sure what I'm missing.


       <select name="a">
         <option value="2003" &+SEL_a2003;>2003
         <option value="2004" &+SEL_a2004;>2004
         <option value="2005" &+SEL_a2005;>2005
         <option value="2006" &+SEL_a2006;>2006
       </select>

       <select name="A">
         <option value="2003" &+SEL_A2003;>2003
         <option value="2004" &+SEL_A2004;>2004
         <option value="2005" &+SEL_A2005;>2005
         <option value="2006" &+SEL_A2006;>2006
       </select>


  - Ben Parker wrote:

>When did you set this?
>
>There must be some recordable/logable activity on the list, either
>change of
>some SET values, a SUB or UNSUB or DEL, or ..., or a list message
>posting.


------------
Regards,
Randy Klumph
[log in to unmask]

Western Oregon University
Teaching Research Division
345 N Monmouth Ave
Monmouth, OR 97361

http://www.tr.wou.edu