|
Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Wed, 22 Aug 2001 14:34:25 -0400 |
Content-Transfer-Encoding: |
quoted-printable |
Content-Type: |
text/plain; charset=ISO-8859-1 |
Reply-To: |
|
Please elaborate, because I am confused - your comment " ... disable it ... " appears to contradict this excerpt from the manual:
L-Soft international, Inc.
List Owner's Manual
for
LISTSERV®, version 1.8d
5 May 2000
Revision 1
(distribution keywords section, page 166)
Mail-Via= DISTRIBUTE | DIST2 | Direct
This keyword is not available in LISTSERV Lite.
The default value is Mail-Via= DISTRIBUTE. DIST2 is functionally equivalent to DISTRIBUTE, and is included for historical reasons. Mail-Via= Direct causes LISTSERV to ignore the DISTRIBUTE algorithm for subscribers on the local system, but mail to non-local subscribers will still go out on the DISTRIBUTE backbone.
>>> [log in to unmask] 08/22/01 12:10PM >>>
>An excellent FAQ response by Ben on the paths e-mail takes wrt
>LISTSERV!
>
>"Outbound" is a little too simplified though. It is correct enough for
>command responses, but list distributions may take a significantly
>more perverse route through other LISTSERV sites ...
><soapbox>a feature I'd like to be able to disable (without loss of
>CATALIST)</soapbox>.
"Mail-Via= Direct" allows you to disable it on a list-by-list basis.
Thanks,
--
Jacob Haller, Technical Support
L-Soft international, Inc
http://www.lsoft.com/
|
|
|